Norac UC4+BC+WR2 User Manual download pdf (Page 12)

9

4.3 WING SENSOR INSTALLATION

1. Assemble the Breakaway Sensor Mounting

Brackets (B11) as show in Figure 4 and

Figure 5.

Figure 4: Breakaway Sensor Bracket

Exploded View

Figure 5: Breakaway Sensor Mounting

Bracket Assembly

To assemble the breakaway sensor bracket:

a) Assemble the bolt and nut into the

collar.

b) Grease the bottom edge of the collar

and the angled tube of the base.

c) Place the collar onto the angled tube of

the mounting base.

d) Install the spring between the collar and

the upper ring of the base.

e) Insert tube through assembly and tighten

the collar

2. Mount the sensor bracket on the boom.

If possible, mount the sensor

brackets while the booms are in their

folded position to ensure that they

will not interfere with anything when

the boom is folded for transport.

3. The sensor mounting brackets can be

installed with the mounting base behind

(Figure 8) or in front of the tube (Figure

6).

Mounting the sensor bracket to the

break-away section of the boom may

cause the boom to drop suddenly as

a break-away occurs. This will occur

on break-away sections which lift as

they break away.

For optimal boom tip protection, it is

recommended that the sensor be

mounted within approximately two

feet (60cm) of the boom tip.

Please refer to the UC4+ Spray Height

Control system warranty at the end of the

UC4+ Spray Height Control

Operator’s Manual (M01) for

implications.

4. Mount the NORAC UC4+ ultrasonic sensor

(E02) into the sensor brackets. The sensors

should be oriented forward (ahead) of the

boom (see Figure 6 and Figure 8).

When installing the UC4+ sensors

(E02), start with the smallest serial

number on the left hand side

proceeding to the largest serial

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Comments to this Manuals

No comments