Norac UC4+BC+WR2 User Manual download pdf (Page 13)

10

number on the right hand side

(Figure 9).

5. Sensor cables should run through the

mounting bracket tube and then behind the

member the bracket is mounted onto.

Cable-tie the connector in place. The cable

must not be allowed to hang below the

boom (Figure 6).

Figure 6: Another Acceptable Mounting

Avoid mounting sensors in locations

where they may read from parts of

the boom as shown in Figure 7.

Figure 7: Poor Mounting

(Sensor Reading off Boom)

General mounting rules for UC4+

ultrasonic wing sensors

:

a) In its lowest position, the sensor mouth

must be 9 inches or more from the ground.

b) The bottom of the sensor must be at least 9

inches in front of the spray nozzles.

c) The bottom of the sensor must be at least 9

inches above the spray nozzles.

d) Ensure that there are no obstructions within

a 12-inch diameter circle projected directly

below the center of the sensor.

e) The sensor should be approximately vertical

at normal operating heights.

Figure 8: Sensor Mounting Guidelines

A

B

B

D

C

Ultrasonic

Acoustic Cone

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Comments to this Manuals

No comments