Norac UC4+BC+WR2 User Manual download pdf (Page 16)

4.5 ROLL SENSOR INSTALLATION

Mount the roll sensors to the included roll

sensor brackets using the machine screws and

nylon lock nuts. (Figure 13)

The roll sensors must be mounted

tightly to the brackets.

Figure 13: Mounting the Roll Sensor

When mounting the roll sensors use the

following guidelines and refer to Figure 14.

a) The smaller the distance between A and B

in Figure 14, the better the performance

will be.

Distance A cannot be more than 12”.

b) The roll sensors must not be mounted

below the pivot point.

c) Ensure the roll sensors are sitting relatively

level when the sprayer chassis and boom are

level.

d) Both roll sensors must be mounted with the

circular AMP connector facing towards the

Right-Hand Wing (when looking from the

rear of the sprayer).

Figure 14: Mounting Guidelines for Center Pivot Sprayers

Connectors towards

Right-hand Wing 

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

No comments

Norac UC4+BC+WR2 User Manual Page 16